
I'd fitted a cheap tail tidy off eBay on my FZ6 that had turned into a rusty lump in no time at all, so when I picked one for the DRZ I went for a bit more expensive alloy one. Again from eBay, but this time from R & G.
I must say the instructions were more like suggestions on how to fit and the wiring diagram for the new tail light was none existent. I worked it all out anyway, though if you are not an electrical type you may not feel confident cutting off plugs. Plus the supplied connectors were not sealed so needed a bit of self amalgamating tape around to keep water out of the wiring loom.
So all in all, it did what it said on the tin, but took a lot longer to fit than you would expect with all of the additional fiddling about.